| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Automatic Transmission/Transaxle | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002ZLK00EX |
| Title: A750E AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Insert the floor shift transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.
Torque: 5.5 N·m (56 kgf·cm, 49 in·lbf)
|
(b) Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip. |
|
(c) Connect the control cable end to the shift lever. NOTICE:
Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable end's ridged side is facing upward. |
(d) Move the shift lever to N.
|
(e) Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position. |
|
(f) Connect the control cable with a new clip and the nut. NOTICE:
When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the inside of the vehicle. |
|
(g) Connect the transmission control cable support with the nut. Torque: 5.5 N·m (56 kgf·cm, 49 in·lbf) |
2. INSTALL FRONT CONSOLE BOX ASSEMBLY
(a) Install the front console box assembly
.
3. INSPECT SHIFT LEVER POSITION
4. ADJUST SHIFT LEVER POSITION
|
|